video on demand/usr/share/doc/initscripts*/sysconfig.txt
11.1 About Network Interfaces
Prev Chapter 11 Network Configuration Next
11.1 About Network Interfaces
Each physical and virtual network device on an Oracle Linux system has an associated configuration file named ifcfg-interface in the /etc/sysconfig/network-scripts directory, where interface is the name of the interface. For example:
# cd /etc/sysconfig/network-scripts
# ls ifcfg-*
ifcfg-eth0 ifcfg-eth1 ifcfg-lo
In this example, there are two configuration files for Ethernet interfaces, ifcfg-eth0 and ifcfg-eth1, and one for the loopback interface, ifcfg-lo. The system reads the configuration files at boot time to configure the network interfaces.
The following are sample entries from an ifcfg-eth0 file for a network interface that obtains its IP address using the Dynamic Host Configuration Protocol (DHCP):
DEVICE="eth0"
NM_CONTROLLED="yes"
ONBOOT=yes
USERCTL=no
TYPE=Ethernet
BOOTPROTO=dhcp
DEFROUTE=yes
IPV4_FAILURE_FATAL=yes
IPV6INIT=no
NAME="System eth0"
UUID=5fb06bd0-0bb0-7ffb-45f1-d6edd65f3e03
HWADDR=08:00:27:16:C3:33
PEERDNS=yes
PEERROUTES=yes
If the interface is configured with a static IP address, the file contains entries such as the following:
DEVICE="eth0"
NM_CONTROLLED="yes"
ONBOOT=yes
USERCTL=no
TYPE=Ethernet
BOOTPROTO=none
DEFROUTE=yes
IPV4_FAILURE_FATAL=yes
IPV6INIT=no
NAME="System eth0"
UUID=5fb06bd0-0bb0-7ffb-45f1-d6edd65f3e03
HWADDR=08:00:27:16:C3:33
IPADDR=192.168.1.101
NETMASK=255.255.255.0
BROADCAST=192.168.1.255
PEERDNS=yes
PEERROUTES=yes
The following configuration parameters are typically used in interface configuration files:
BOOTPROTO
How the interface obtains its IP address:
bootp
Bootstrap Protocol (BOOTP).
dhcp
Dynamic Host Configuration Protocol (DHCP).
none
Statically configured IP address.
BROADCAST
IPv4 broadcast address.
DEFROUTE
Whether this interface is the default route.
DEVICE
Name of the physical network interface device (or a PPP logical device).
HWADDR
Media access control (MAC) address of an Ethernet device.
IPADDR
IPv4 address of the interface.
IPV4_FAILURE_FATAL
Whether the device is disabled if IPv4 configuration fails.
IPV6_FAILURE_FATAL
Whether the device is disabled if IPv6 configuration fails.
IPV6ADDR
IPv6 address of the interface in CIDR notation. For example: IPV6ADDR="2001:db8:1e11:115b::1/32"
IPV6INIT
Whether to enable IPv6 for the interface.
MASTER
Specifies the name of the master bonded interface, of which this interface is slave.
NAME
Name of the interface as displayed in the Network Connections GUI.
NETMASK
IPv4 network mask of the interface.
NETWORK
IPV4 address of the network.
NM_CONTROLLED
Whether the network interface device is controlled by the network management daemon, NetworkManager.
ONBOOT
Whether the interface is activated at boot time.
PEERDNS
Whether the /etc/resolv.conf file used for DNS resolution contains information obtained from the DHCP server.
PEERROUTES
Whether the information for the routing table entry that defines the default gateway for the interface is obtained from the DHCP server.
SLAVE
Specifies that this interface is a component of a bonded interface.
TYPE
Interface type.
USERCTL
Whether users other than root can control the state of this interface.
UUID
Universally unique identifier for the network interface device.
Prev Up Next
Chapter 11 Network Configuration Home 11.2 About Network Configuration Files
Oracle logo
Copyright © 2013, 2014, Oracle and/or its affiliates. All rights reserved. Legal Notices